The system contains sufficient reagents suitable for 200 amplification reactions of 50 μl each.
The product has two packages, one contains bromophenol blue, and the other doesn’t. Default package contains bromophenol blue.
Plus 2X Mix is a premixed, ready-to-use solution containing Plus DNA Polymerase, dNTPs, MgCl2 and Reaction Buffer at optimal concentrations for efficient amplification of DNA templates by PCR. To prepare the final PCR, only primers and template DNA are added. Plus Mix contributes to highly reproducible PCR by reducing the risk of pipetting errors, miscalculation and contamination. It also contributes to higher sensitivity by adding enhancer.
Taq Plus, a mixture of taq and pfu polymerase, blends the processivity of taq with the high fidelity of pfu. Therefore, this specially formulated Taq plus allow amplification of the higer fidelity and longer templates than the single-enzyme formulations. It is also a better choice for amplifying complex template, such as GC-rich template. And it is suitable as a direct replacement for ordinary Taq Polymerase in most applications. In addition, Using Taq plus results in 3′-dA overhangs PCR products, which can be used in TA clone.
Convenient : only primers and template DNA are added when prepare final PCR
High efficiency: saving your time by simplifying the process
Reproducible: reducing the risk of pipetting errors, miscalculation and contamination
Long PCR with high fidelity
High reproducible PCR for complex templates
High throughput PCR for complex templates
Generation of PCR products for TA cloning
One unit is defined as the amount of the enzyme required to catalyze the incorporation of 10 nM of dNTPs into an acid-insoluble form in 30 minutes at 70°C using hering sperm DNA as substrate.
2×PCR Plus Mix
0.4U/ul Taq Plus DNA polymerase, 2x PCR Buffer, 0.4mM dNTPs, 4mM MgSO4, 0.02% bromophenol blue.
Store at -20°C.
Basic PCR Protocol
1. Add the following components to a sterile 50 μl microcentrifuge tube sitting on ice:
2. Mix contents of tube and overlay with 50 μl of mineral or silicone oil.
3. Cap tubes and centrifuge briefly to collect the contents to the bottom.
4. Incubate tubes in a thermal cycler at 94°C for 3 minutes to completely denature the template.
5. Perform 25-35 cycles of PCR amplification as follows:
6. Incubate for an additional 10 min at 72°C and maintain the reaction at 4°C. The samples can be stored at -20°C until use.
Notes on cycling conditions
ü Initial denaturation can be performed over an interval of 1-5 min at 95℃ depending on the GC content of template.
ü Optimal annealing temperature is 5℃ lower than the melting temperature of primer-temperature DNA duplex. If nonspecific PCR products are obtained optimization of annealing temperature can be performed by increasing temperature stepwise by 1-2℃.
ü The number of PCR cycles depends on the amount of template DNA in the reaction mix and on the expected yield of the PCR product. 25-35 cycles are usually sufficient for the majority PCR reaction. Low amounts of starting template may require 40 cycles.
ü The time of the final extension step can be extended for amplicons that will be cloned into T/A vectors.
7. Analyze the amplification products by agarose gel electrophoresis and visualize by ethidium bromide staining. Use appropriate molecular weight standards.